This is Breadboard Jumper Dupont 2.54MM 1P-1P Cable 40 Pcs. A very Flexible and easily detachable cable to the no. of wires according to your requirement. It has 1Pin male to the 1pin male header with both ends. Also, it is compatible with 2.54 mm mil spacing pin headers.
This cable is an electrical wire or group of them in a cable with a connector or pins at each end, which is normally for interconnecting the components of a breadboard or other prototype or test circuit, internally or with other equipment or components, without soldering.
Individual Dupont Cables are fitted by inserting their “end connectors” into the slots provided in a breadboard, the header connector of a circuit board, or a piece of test equipment.
Compatible with 2.54mm spacing pin headers, 10 CM, 20CM , 30CM
40pcs chromatic color jump wire
High quality and in good working condition
Durable and reusable
Easy to install and use
A popular choice for construction or repair
Be used for the electronic project and Genuine Arduino product
Flexible Breadboard Jumper Cable Wire allows you to plug and unplug easily for prototyping.
Heat shrink is the lifeline of an engineer dealing with electronics and electrical circuits. This heat shrink comes in four different colors - red, blue, yellow, and the traditional black.
Heat shrink keeps your stuff all safe and kept together. Especially when wiring and soldering, use heat shrink to add mechanical strength to cables. The colors can be used to color-code different wires so you know which wire is power, data, ground, analog in, etc
The package will contain a single meter of heat shrink of whichever color and size you choose from the options.
Solderless and crimpless, all you need is just a heat gun to finish the joint, much faster and easier than the old way.
Fit for Confined and Narrow Spaces - can be bent after connection and no need to crimp or solder in the confined area, just control the temperature via a heat gun.
Better Waterproof and Seal Performance - there is two hot melt waterproof adhesive rings in each butt connector, which help it hold up better to moisture.
High Temperature Resistance in A Short Time: use exclusive material in the butt connectors to avoid shrink tubing melting before solder ring.
Shrinkage ratio is 3:1
Temperature that start to shrink: 80℃
Temperature that solder ring start to melt: 111˚C
Temperature that solder ring melt completely：138˚C
NOTE: Temperature of surface of the connector is what is mentioned above, rather than the temperature that the hot air gun should set.
MIX Pack contains 5 pcs of each type of connector.
Great cables to work with all kinds of breadboard and Arduino components
Includes 40-pin male to female + 40-pin male to male + 40-pin female to female
Fits perfectly into standard 0.1"(2.54mm) female sockets on breadboards
The cables can be separated to form an assembly containing the number of wires you require for your connection and to support non-standard odd-spaced headers
Made of high-grade copper wire material for safe and durable to use
The High-Quality 16AWG Soft Rubber Conductor Wire 1m has a quite large diameter compared to the everyday 20AWG cord utilized in RC tasks for serving its particular purpose. This cord has low resistance and excessive present-day wearing ability. These also are utilized in LiPO batteries to deliver strength to ESCs.
Ideal for your RC project. It is top-notch bendy and gentle with excessive strand matter this means that it's far splendid to be used in restrictive and compact areas. The cord is the primary precedence device for wearing present-day from one circuit to different whilst their present-day wearing ability depends upon the dimensions of the cord.
So the High-Quality 16AWG Soft Rubber Conductor Wire 1m has the widespread diameter to fit your application. The same size of cable available in both Red, Black, Green, and Blue Color. The package includes a 1-meter cable of the chosen color, without roll casing.
Application: Internal wiring in electric & electric equipment, toys, lighting fixtures, DIY
Type: Stranded Wire Insulator
Material: Soft Rubber Conductor
Material: Tinned Copper Conductor
22/0.14TS (include 22 copper wires with a diameter of 0.14mm)
Maximum Conductor Resistance: 39.5 ohm/km. (at 20 degree)
Rated Temperature: -60 to 150 Celsius
Rated Voltage: 300V
Colors: Black, Red, Green, Blue,
Certification: UL (E355578), RoHS, TS/16949
Heat shrink is the lifeline of an engineer dealing with electronics and electrical circuits. This heat shrink comes in five different colors - red, blue, green, yellow, and the traditional black.
Each pack contains 45mm (1.8") long tubes in the following diameter (D) and quantities:
80 pcs - ⌀1mm X 38mm L
50 pcs - ⌀2mm X 38mm L
30 pcs - ⌀2.5mm X 38mm L
30 pcs - ⌀3.5mm X 38mm L
40 pcs - ⌀4mm X 45mm L
30 pcs - ⌀5mm X 45mm L
20 pcs - ⌀10mm X 45mm L
80 pcs - ⌀1.5mm X 38mm L
20 pcs - ⌀6mm X 45mm L
50 pcs - ⌀2mm X 38mm L
30 pcs - ⌀3mm X 38mm L
30 pcs - ⌀3mm X 38mm L
20 pcs - ⌀10mm X 45mm L
30 pcs - ⌀4mm X 45mm L
20 pcs - ⌀8mm X 45mm L
It's a nice colorful mixed bag of heat shrink!
Heat shrink keeps your stuff all safe and kept together. Especially when wiring and soldering, use heat shrink to add mechanical strength to cables. The colors can be used to color code different wires so you know which wire is power, data, ground, analog in, etc.
140 quality jumper
Color: red, orange, yellow, green, blue, purple, gray, brown, white.
Box size: 165 × 55 × 10mm;
length of the line is not the same length, the length of the line, a total length of 14 length 10 each, a total of 140
140 pcs of 22 AWG solid wires
Including length: 2,5,7,10,12,15,17,20,22,25,50,75,100, and 125 mm
Crimp easily without splitting to secure the connection in place
Standard crimp and seal heat shrink butt connectors
Guaranteed to hold the strong crimps
Dual-walled design, polyolefin tubing outside and hot melt adhesive inside
Prevents corrosion, and provids a waterproof seal
For best results use a hot air gun until it reduces in size and the adhesive flows, filling gaps within the terminal
AWG 26-22 0.3 - 0.5 mm²
AWG 22-18 0.5 - 1.0 mm² (Red)
AWG 16-14 1.5 - 2.5 mm² (Blue)
AWG 12-10 4.0 - 6.0 mm² (Yellow)
This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5×2.1mm, center-positive male or female barrel jack.
If you need to connect bare wires to a barrel jack on Arduino, Raspberry Pi or any other development board, this connector offers a simple solution.
Package Contains 1 barrel jack terminal connector.
9V Battery connector is used to connect any 9V battery to a circuit. This is the best solution to have a safe and reliable power delivery perfect for project prototypes.
+/- prominent connector
12 cm wire length
Plastic head for protection
This cable serves specific application areas accounting to its PVC coating. The use of PVC coating blends these wires with special properties such as self – extinguishing and flame retardant, also Conditionally resistant to oils, solvents, acids, and dyes.
The UL1007 26AWG PVC Wire is used in household wiring application such as switchboards, electronic and electrical equipment. This PVC wire comes with Annealed plain or tinned stranded copper conductor. So, the conductors remain same as found in our silicon coated wires.
Available in 8cms and 20 cms
Since most of the servos in the market have a relatively small length cable. It sometimes becomes impossible to use them where the signal board is much further away. Servo extension cables solve this problem by extending the cable so it can be attached to boards at greater distances. The cable is strong and reliable to withstand the stress and current specifications of any servo in the market.
One male and one female connector.
Flat 30 cm Servo Lead Extention (JR)
Quality wire and connectors used.
Great for larger planes with servos that experience high loads
Color: Black, Red, White
Stranded Wire Kit: Six 22 gauge wire spools, 25 ft. each. Tinned copper wire. Assorted colors: Red, black, green, yellow, blue, white. All 6 spools are contained in a cardboard dispensing box, which keeps hook-up wire neat and clean. Insulation: PVC . 010". Temperature Rating: -55 degrees C to 105 degrees C. Voltage Rating: 300 Volts. Resistant to water, oil - also flame retardant.
Six 22 gauge wire spools by electronix express
Each wire spool is 25 feet in length
Insulation: pvc 010
Voltage rating: 300 volts R.M.S
packed included 1pc
These useful 10-pin (2×5) shrouded male box headers are a dual row shrouded header for use with dual row IDC female socket connectors. The low profile, space saving design has a centre slot for the socket's polarization bump. Pins 0.1in pitch (2.54mm).
DC3-10P 2 Row 10 Pin 2.54mm pitch. It can also be with our Flat Ribbon Cable.
Product Name : DC3-10P
Material : Plastic, Metal;
Pitch : 2.54mm / 0.1";
Total Size : 20 x 9 x 12mm / 0.79" x 0.35" x 0.47" (L*W*H)
Color : Black, Silver Tone;
Weight : 130g
Package Content : 2 pieces of DC3-10P
We are PCI-DSS compliant and use 256 bit SSL encryption.
99% of our orders are shipped within 24 hours.
Use the contact form for bulk order quotes.
Call us (Weekdays)
+91 93183 94903
India: Rani Bagh, New Delhi 110034 +91 93183 94903
USA: 405, Kennedy Space Center, FL 32899 | +1 (321) 210-8472
Hong Kong: Unicorn Trade Centre, 127-131 Des Voeux Road, Central HK